The Process... The Interview
Our Custom Fit will begin with fact-finding. Questions help me identify your ball-flight tendencies, equipment specifications, your likes and dislikes about your current set and your needs and preferences from new equipment. This will continue to be discussed throughout the fitting to ensure that your expectations are being met every step of the way. Static Measurement
For an iron fitting, your height and wrist-to-floor measurement are taken to help calculate your static iron lie angle and shaft length and your hand dimensions are used to calculate your static grip size. Dynamic Swing Test
For an iron fitting, you will hit a few golf balls from an impact board with special tape on the sole of the club. When the club hits the board, it will leave a mark on the tape that helps me better understand how your setup, posture and swing affect the clubhead’s position at impact. I then make adjustments to arrive at your length and lie angle measurements.
For drivers, fairway woods and hybrids, my launch monitor is used to analyse impact location, swing habits and ball flight for consistency and to determine the optimal shaft characteristics. Ball-Flight Analysis
Every step of the way, we will refer back to ball flight improvements. This process helps determine the combination of model, loft, colour code, shaft length and flex, and grip that gives you the best opportunity to achieve your optimal ball flight.
|